Altana Haze-Gloss Manual Manual de usuario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 128
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
GLOSS CALIBRATION
Measure High-Gloss
--> OPERATE
Escape:
SAMPLE
GLOSS CALIBRATION
20° Calibration ok
90.2
60° Calibration ok
93.3
85° Calibration ok
99.1
set up
operate
Move down the sample support table
using the hand lever and insert black
high-gloss standard.
If your haze-gloss is equipped with a
motorized sample table you can
alternatively use the footswitch.
The calibration cycle for the single
angle geometries is now performed
automatically.
SET UP MENU
Haze Compens.:
Calibration
Measure autom:
Target:
Lower:
Decimal Point:
Escape:
on
on
on
4cm
on
SAMPLE
GLOSS CALIBRATION
20° Calibration ok
90.2
60° Calibration ok
93.3
85° Calibration ok
99.1
set up
operate
Move down the sample support table
using the hand lever and insert black
high-gloss standard.
If your haze-gloss is equipped with a
motorized sample table you can
alternatively use the footswitch.
The calibration cycle for the single
angle geometries is now performed
automatically.
SET UP MENU
Haze Compens.:
Calibration
Measure autom:
Target:
Lower:
Decimal Point:
Escape:
on
on
on
4cm
on
SAMPLE
GLOSS CALIBRATION
Measure High-Gloss
--> OPERATE
Escape:
SAMPLE
Select Calibration
Routine
Call Calibration Routine
Note
Make sure that the glass standard is
clean and has no scratches!
Select Calibration
Routine
Call Calibration Routine
Note
Make sure that the glass standard is
clean and has no scratches!
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 127 128

Comentarios a estos manuales

Sin comentarios