Altana Micro-Wave-Scan Manual Manual de usuario descargar pdf (Pagina 21)

Getting started

After completing a measurement, the

measurement results are displayed. Performing

the measurement requires some practice. The

following error messages are especially likely to

occurduringthersttrials.

A warning signal is heard and the light diode

ashesatarapidrate.Atthesametime,a

message appears in the display indicating the type

of error:

Speed

You have moved the measurement unit too

quicklyorunevenlyoverthesample.Conrmthis

information by pressing the operate button and

repeat the measurement.

Scan length

The required scan length has not been reached

completely.

Repeat the measurement, moving the device until

ashortaudioconrmationisheard.

Small areas can be measured by moving the

instrument back and forth.

Acceleration

The instrument was accelerated too fast across the

specimen or the scan direction was changed too

fast.

Conrmthemessagebypressing“operate”and

repeat the measurement.

Scan length

Error

Acceleration

Error

Speed

Error

SAMPLE 01 n=1/1

du 8.1 Wd 7.8

Wa 10.8 SW 15.7

Wb 17.4 LW 7.3

Wc 8.7

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 61 62

Sin comentarios

Altana Micro-Wave-Scan Manual Manual de usuario Pagina 21